To ensure optimal machine performance, follow the machine lubrication diagram and add oil to each oil cup's lubrication points accordingly. Additionally, manual lubrication should be carried out when necessary as indicated by the diagram.
To achieve the desired result, follow the plate bending machine's instructions and carefully roll the plate. The coil should be 20mm thick and no longer than 2500mm in length. It is important to note that the coil material should have a yield limit below 250Mpa. Maintaining these parameters will ensure successful plate rolling.
To ensure the proper functioning of the machine, it is crucial to carry out a few checks before starting the work. One of the essential checks is to test the movements of the upper and lower rollers. After turning on the power, carefully monitor the movement of the lower roller in both positive and negative directions. If it gets abnormally stuck, it could indicate a malfunction. Similarly, test the lifting movement of the upper roller to see if it's working correctly or not. Any abnormal behavior during these checks must be thoroughly investigated before starting any work.
It is crucial to adhere strictly to the processing procedures and operating methods of the rolling plate. Additionally, it is crucial to exercise caution when the upper roller is lifted to its maximum position to guarantee the safety of the equipment during operation.
During the operation, it is essential for all personnel to maintain coordination among themselves. It is imperative to strictly follow the instructions provided by the person responsible for the rolling plate. Furthermore, it is crucial that no one initiates the machine without the authorized password.
When carrying out plate rolling tasks, safety should always be your top priority. This is because there is a risk of your hands becoming trapped by the steel plate and possibly being rolled up along with it. So, it's crucial to be cautious and take all necessary precautions to prevent accidents and protect yourself from harm.
In case the main drive is not functioning, there are certain actions that can be carried out. Firstly, the upper roller has the capability to be raised or lowered as required. Secondly, the overturned bearing can be tilted and readjusted to its original position. Lastly, the upper roller can also be tilted for specific purposes. These activities provide flexibility and allow for maintenance or repairs when necessary.
If any irregular noise or impact is detected during operation, it is important to promptly shut down the system for inspection and investigation. Immediate action should be taken to address the issue and ensure the smooth functioning of the equipment. Identifying and addressing any unusual sounds or impacts is crucial for maintaining the safety and efficiency of the operation.
Make sure to exercise caution when using a crane to lift a steel plate or drum, as it is important to avoid any collisions with the surrounding machinery.
Once the coiling work is completed, it is vital to promptly clear the site of the finished materials and ensure the power supply is switched off. It is essential to follow these steps to maintain a safe working environment and prevent any potential hazards.